The two part Contractor Hinge Jig is a portable template set designed for recessing hinges in wooden doors & frames using a plunge router.
It is easy to use with minimal setting-up time completing the job both accurately & quickly.
Used on-site & in joinery shops to increase productivity with excellent results.
Four apertures for fire door requirements.
No need for marking out in the conventional way.
Quick & simple to set-up as the hinge is used as the pattern.
Clean & accurate recesses are achieved every time. Suitable for timber based doors & square butt hinges.
Can be used on both inside and outside doors rebated frames and on maximum 25mm thick fixed stops.
Use with a light duty plunge router with 1/4 inch collet.
Long reach router cutter required 12mm diameter with 70mm overall length.
Angled position slots to prevent creep.
Unibase may be needed.
T4EK router requires a ref. UNIBASE or special guide bush ref. GB/T4/160.

Specification:
Length min.=2 5/8inch (67 mm)
Length max.=5inch (127 mm)
Width min.=3/8inch (9.5 mm)
Width max.=1 3/8inch (35 mm)
Width max. in 35mm rebate=20 mm
Width max. in 44mm rebate=30 mm
Door sizes possible
Height min.=6?5inch (1955 mm)
Height max.=2100 mm*
Thickness min.=5/8inch (16 mm)
Weight=3.3 kg
Jig overall length=1957 mm
Plate thickness=2 mm
Fixed stop max. thickness=25 mm**
* Please note for doors over 2040mm the bottom hinge will be higher than 9inch up.
** Max. hinge leaf width 20mm (35mm doors)
Thickness max.=2inch (51 mm)

Includes:
4 x Apertures
2 x Bradawls with spacer
1 x 16mm guide bush
1 x T-Handle hex key 4mm
1 x 4mm spacing gauge
1 x Carry case